How to Achieve SS Reverse of Direction

In order to make it convenient for customers to locate the products at the operation side or the non-operation side, the arm of Shini SS series are fixed by two trapezoidal grooves that cross with each other. Release the screw that binds the arm when reverse rotation direction is demanded, and rotate the trapezoidal convex block into the other trapezoidal groove. Then fasten the screw and turn the DIP switch to the other end to finish it. The detailed descriptions are as follows: (Default value of this equipment before delivery is locating the products at the non-operation side, and the following instruction refers to the opposite direction)

• Release the screw that bind the arm, and fasten them after moving the arm 90 degrees counterclockwise. The arm is now in horizontal status

• After adjusting the arm, turn the DIP switch on the circuit board from "L" to "R" when cutting off power and gas. The arm is nearly in perpendicular condition

• Regulate the hydraulic buffer on the sliding saddle to make the arm totally vertical. The open direction of the fixture and glide direction of the sliding saddle are mutually perpendicular now

• Loosen the screw that fasten the fixture, and fix it after rotating the fixture 90 degrees clockwise to make the open direction of the fixture and glide direction of the sliding saddle parallel to each other